Ftdi Mobile Phones & Portable Devices Driver Download For Windows

 



  1. Ftdi Mobile Phones & Portable Devices Driver Download For Windows 10
  2. Ftdi Mobile Phones & Portable Devices Driver Download For Windows 8

Smart phones serial terminal program. USB equipment using Silicon Laboratories CP210X, FTDI FT232 and Prolific PL2303, CDC/ACM UART to USB Bridge chips can be used to connect to your smart phone. The phone is running the USB Terminal app. Note: some Android phones do not support USB host mode. To check if yours does, I recommend this app. When I first connected my Arduino to the Phone it did not recognize the connection. I found out that my FTDI chip had an incorrect product id. Megawin port devices driver download for windows 8.1. The product id was all zeros and needed to be 6001.

For

Connecting an Android Phone to an Arduino could not be easier. All you need is an OTG cable. I wrote a previous post here about connecting and controlling an Arduino from your Android device. Previously, I had always connected real Arduinos. This time I tried connecting my DIY Arduino.

Pictured above is my Samsung S5 (G900H) connected to my DIY Arduino via an FTDI converter and a white OTG cable. The FTDI converter would normally be plugged into your Host PC USB port. With the OTG cable, the Android Phone functions as the host. Delphin Driver Download for Windows 10. From the screen shot of the phone, you can tell that the Arduino is loaded with the Minipirate sketch. The phone is running the USB Terminal app. Note: some Android phones do not support USB host mode. To check if yours does, I recommend this app.

When I first connected my Arduino to the Phone it did not recognize the connection. I found out that my FTDI chip had an incorrect product id. The product id was all zeros and needed to be 6001. There is a solution to fix this called ft232r_prog. This Linux command line program allows you to reconfigure (i.e. flash) the FTDI chip. It is a few years old and does not compile on my version of Fedora. (At the time of this post, I am using Fedora 24.) It does however compile fine on an Ubuntu distro. I used YUMI to boot into a live Ubuntu image to compile and run it. Here are the commands to install the prerequisites, compile and change the product ID on an Ubuntu system:

Compile fr232r_prog